Applying Epoxy Coating to Your Garage Floor

Whatsoever epoxy products and paint we usage, the process remains similar. Smearing epoxy coating to your garage floor can be enclosed in three key phases. In going through the events, do not disremember to wear protective glasses and gloves.

Let’s deal with all the walls of the garage.  Stick vinyl sheeting on the walls upward into the elevation to which you would like the glue applied. You can also get best water-resistant services in sunshine coast by clicking here.

spa

If you merely wish to apply epoxy on the ground then stick the vinyl sheeting onto the wall near the ground.  Then sweep the whole region and remove all dust and dirt.  Do so thoroughly, and remember to also clean out the corners and corners.

Once we’ve made certain the garage flooring is dust-free, it is time to reinstall the ground.  We combine an etching solution with water at a watering can.  Follow the manufacturer’s directions about the etching solution, and do not forget to use protective gloves, rubber boots, and safety glasses.

We wet the ground prior to massaging the etching solution at the farthest corner of the garage flooring.  Pour the solution just on a 10×10 ft. square place.

From this region, we wash first in 1 direction and then go on it in a vertical direction.  Use a bristle broom in scrubbing the ground.  Repeat this procedure in tiny sections until you have covered the entire floor.

Leave a Reply

Your email address will not be published. Required fields are marked *